Decorative Concrete of Austin
Austin, TX, USA
2. You will find groutable vinyl tiles available on the market now that look incredibly great, get the look of tile without the cracking potential.
This may save me the $$ over the shot blaster, leveling plus a subfloor merchandise. And would offset the cost on the composite material.
– The stairs are a bigger issue. The code requires that stair heights match within a particular tolerance. So around here we check out to get stairs be seven″ increase with a most deviation of 1/two″ from stair to stair. So basically you’re left with a few options.
@ Mike – I don’t think there’s Considerably distinction between the 150 and 250 for the application. I do Consider it is best to persist with T&G as it really stiffens the floor.
My basement floor is very dry and I really don’t choose to do a subfloor. I’d somewhat do carpet padding and carpet.
I have a basement which was concluded by earlier entrepreneurs. They did 2×four specifically around the cement. Then did batt insulation and vapor barrier and afterwards drywall. Now about half of your wall has mould rising as well as drywall is quite comfortable for around 2 ft with the floor.
Well, There's a lot of humidity in the bottom, even so I have drain tile to the inside and out of doors from the foundation and Even though my sump operates alot, I haven't experienced dampness inside.
1. I have browse nearly most of the basement floor concerns and solutions and spot that although you to begin with endorse sleepers about the XPS and beneath the AdvanTech, you seem to simply accept the elimination of sleepers in subsequent posts, so……….
We now have noticed that the dryway was grading into the house Within this part. The dryway was redone along with the grading was fastened. I’m likely to remove this part and then rebuild with 2inch within the floor and wall read more about concrete staining austin tx but I’m wondering if I get weeping tile issue due to the fact its a sixty yr previous will the 2inch Foam within the floor be a good idea or would something like drycore be a greater thought to channel the extra dampness.
With the recommendation and support from a web page I have insulated my visit here for stained concrete company austin basement walls And that i am preparing for your floors. I am about info on stained concrete company austin tx to use the 1″ foam and afterwards the 3/four Advantech ply on major. I have an issue re the adhesive for that floor. I had been “bought” some PL200 that was proposed to me through the Foam distributor – “that’s what everyone uses” I was advised; nevertheless, I took your tips to the walls and utilized The good stuff foam sealant/glue and it labored very well.
After all, you could go to Home Depot and buy strippers which might be specially made to remove urethanes and epoxies, correct? He mentioned there’s not one that would remove polyurea.
So I had him mix within a little of your additive just to dull the shine a little little bit, although not a great deal that I'd find yourself with a sandpaper-sensation countertop, and so, not a matte complete.
Todd- What could you notify me about using Platon for just a dry/insulating layer instead of foam? We didn’t take into consideration foam until finally examining your short article. Also, we want to install the subfloor layers before framing the basement walls. Must we set the foam boards over the cement block walls right before installing the flooring levels?
It’s not that common, at times we get it done to simplify the foundation. Without the designs there’s no way to inform.